Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the pro arrives.
Get your free estimateGenie Cable & Drum Replacement: The Summerlin Owner’s Guide
We replace Genie-compatible cables and drums in Summerlin, and most jobs run $130 – $250 installed, quoted before we start. If your door is hanging crooked or a cable has snapped, call (855) 608-8802 and we’ll tell you honestly whether it’s a cable-and-drum job or something else. Same-day repair is often possible when you reach us in the morning.
Owners usually find this problem the hard way. The door comes down at an angle and one side sits higher than the other. Or you hear a sharp crack from the garage, walk out, and find a steel cable coiled on the floor like a dropped snake. Sometimes the door won’t move at all because the drum has stopped winding the cable cleanly. In Summerlin, we see a lot of this on Genie doors that have run for years through our dry heat and monsoon dust without anyone looking at the cables.
A quick word on affiliation: Mainspring Garage Door Co. Summerlin is an independent service provider. We’re not affiliated with Genie, and we’re factory-familiar with the brand the same way we are with LiftMaster and Chamberlain.
Which Genie Models This Applies To
Cable-and-drum systems aren’t tied to one model line. Practically every residential Genie door that uses a torsion spring across the header also uses a pair of drums and two lift cables, one on each side. What changes between doors is the drum profile, the cable diameter, and the way the drum attaches to the torsion shaft.
The surest way to identify what you have is the label on the opener head or the back of the door panel. Genie has built a wide range over the years, from older screw-drive units to the current chain and belt models, and the door hardware is separate from the opener anyway. So the label tells us what motor you have, and the drum and cable are matched to the door by measuring. We check cable diameter (commonly 3/32″ or 1/8″ on residential Genie doors), drum groove width, and the drum’s set-screw pattern on the shaft.
On the OEM question, we’re direct: a genuine Genie drum is a solid part, but quality aftermarket drums and cables from established makers fit the same specs and often last just as long at a lower price. We’ll show you both and let you choose. What we won’t do is put a cheap offshore cable on a door that carries real weight. For Summerlin owners, the honest recommendation is usually a good aftermarket cable with a matched drum, because the failure points are the same either way.
Styles & brands we work with
- Raised-panel steel
- Carriage house
- Modern flush
- Full-view glass
- LiftMaster openers
- Chamberlain openers
Signs Your Genie Cable & Drum Replacement Is Failing
Five symptoms we see on Genie doors around Summerlin, and what’s actually going on underneath each one:
- Door hangs crooked or won’t close flush. One cable has stretched or slipped its drum groove, so the two sides are no longer lifting in sync. Left alone, the door can bind and bend a track panel.
- A loud snap, then the door won’t move. That’s a cable letting go. The spring is still wound with stored tension, so the door is now unsafe to operate by hand.
- Cable looks frayed, kinked, or is unwinding off the drum. Wear and dust. Cables that jump the groove can chew the drum’s edge and must be replaced as a pair.
- Drum is cracked, or the set screws have walked loose. The drum is spinning free of the shaft instead of winding the cable. This is a hardware failure, not an opener problem.
- Grinding or popping from the header as the door travels. A worn drum and a stretched cable are fighting each other. Left longer, the shaft and bearing plates take the stress.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
For Summerlin, cable-and-drum work sits in our Cable Repair range of $130 – $250 installed for a standard residential door. What moves you within that range: number of cables replaced (one or both), whether the drums are replaced too, cable diameter and length, and whether the door needs re-leveling after the swap. If a bent track or damaged panel is also in play, that’s separate work and we’ll quote it plainly.
Here’s how the price breaks down for you:
- Parts: cables and drums, OEM or quality aftermarket, at a price we state up front.
- Labor: the removal, the install, and balancing both sides so the door runs true.
- Not included: springs, opener repair, or panel work. If we find any of that while we’re in there, we tell you before touching it.
Every cable-and-drum job we do is covered by our 90-Day Done Right Promise: if it isn’t right, we come back, in writing, no arguing. The flat price is quoted and agreed before any work starts, so there are no surprises on the bill.
DIY or Call Us?
We’ll be honest about what’s safe. You can look at the cables and drums visually and describe what you see. You can check that the door runs level in the closed position, and you can take a photo of the label and the drum to send us. That helps us quote accurately.
What you should not do is try to rewind the cable onto a drum, loosen a set screw, or take tension off the torsion spring yourself. The spring holds the door’s entire weight, and the cable is what transfers that load to the drum. A cable under load can snap with enough force to do serious injury, and we’ve seen too many homeowners hurt trying to “just get the door down.” On a Genie system, the drum and the wound spring sit inches apart. If your cable has failed, call us at (855) 608-8802 and we’ll get a technician out to make it safe.
FAQs
A typical Genie cable lasts about 10,000 to 15,000 cycles, and drums a little longer. Here in Summerlin’s dry heat and seasonal dust, we see cables fray faster than in cooler climates, and doors used several times a day can show wear in six to eight years. Call (855) 608-8802 for a free estimate and we’ll tell you honestly where yours stand.
Rarely. A frayed cable, a jumped groove, or a cracked drum can’t be safely repaired back into service, so replacement is the right call. Springs are different, and we’ll check those at the same time. Call for a free second opinion on any written estimate you already have.
Most single-door jobs are done in one visit, usually well under two hours including balancing. Because our technicians have up to 10 years of experience and we handle cables and drums regularly, we won’t waste your afternoon. Call for an exact time slot.
We match the drum and cable to your door by measuring cable diameter, drum groove, and shaft fit, then offer both OEM Genie and quality aftermarket options at quoted prices. You’ll see the part before we install it. Call (855) 608-8802 for a free estimate in Summerlin and nearby areas.
Whether your Genie door needs a cable-and-drum set or you’d just like a straight answer on what’s wrong, call us at (855) 608-8802 for a free estimate. Our phones are answered by a live person around the clock, we’ll state the price before any work begins, and we’ll be there when we say. Current offers include $50 off any repair over $250 and a permanent 5% senior and veteran discount.
Written by the team at Mainspring Garage Door Co. Summerlin, serving Summerlin and nearby areas.