A Mainspring company - serving Summerlin, NV

Genie Cable & Drum Replacement in Summerlin, NV

Raised-panel steelRaised-panel steel
Carriage houseCarriage house
Modern flushModern flush
Full-view glassFull-view glass
LiftMaster openersLiftMaster openers
Chamberlain openersChamberlain openers
Every visit starts with

Full 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included

We have financing partners for your new garage door*On approved credit; ask us about your options

You get a price before we start. It does not change when the pro arrives.

Get your free estimate

Genie Cable & Drum Replacement: The Summerlin Owner’s Guide

We replace Genie-compatible cables and drums in Summerlin, and most jobs run $130 – $250 installed, quoted before we start. If your door is hanging crooked or a cable has snapped, call (855) 608-8802 and we’ll tell you honestly whether it’s a cable-and-drum job or something else. Same-day repair is often possible when you reach us in the morning.

Call (855) 608-8802

Owners usually find this problem the hard way. The door comes down at an angle and one side sits higher than the other. Or you hear a sharp crack from the garage, walk out, and find a steel cable coiled on the floor like a dropped snake. Sometimes the door won’t move at all because the drum has stopped winding the cable cleanly. In Summerlin, we see a lot of this on Genie doors that have run for years through our dry heat and monsoon dust without anyone looking at the cables.

A quick word on affiliation: Mainspring Garage Door Co. Summerlin is an independent service provider. We’re not affiliated with Genie, and we’re factory-familiar with the brand the same way we are with LiftMaster and Chamberlain.

Which Genie Models This Applies To

Cable-and-drum systems aren’t tied to one model line. Practically every residential Genie door that uses a torsion spring across the header also uses a pair of drums and two lift cables, one on each side. What changes between doors is the drum profile, the cable diameter, and the way the drum attaches to the torsion shaft.

The surest way to identify what you have is the label on the opener head or the back of the door panel. Genie has built a wide range over the years, from older screw-drive units to the current chain and belt models, and the door hardware is separate from the opener anyway. So the label tells us what motor you have, and the drum and cable are matched to the door by measuring. We check cable diameter (commonly 3/32″ or 1/8″ on residential Genie doors), drum groove width, and the drum’s set-screw pattern on the shaft.

On the OEM question, we’re direct: a genuine Genie drum is a solid part, but quality aftermarket drums and cables from established makers fit the same specs and often last just as long at a lower price. We’ll show you both and let you choose. What we won’t do is put a cheap offshore cable on a door that carries real weight. For Summerlin owners, the honest recommendation is usually a good aftermarket cable with a matched drum, because the failure points are the same either way.

Explore

Styles & brands we work with

  • Raised-panel steel
  • Carriage house
  • Modern flush
  • Full-view glass
  • LiftMaster openers
  • Chamberlain openers

Signs Your Genie Cable & Drum Replacement Is Failing

Five symptoms we see on Genie doors around Summerlin, and what’s actually going on underneath each one:

  • Door hangs crooked or won’t close flush. One cable has stretched or slipped its drum groove, so the two sides are no longer lifting in sync. Left alone, the door can bind and bend a track panel.
  • A loud snap, then the door won’t move. That’s a cable letting go. The spring is still wound with stored tension, so the door is now unsafe to operate by hand.
  • Cable looks frayed, kinked, or is unwinding off the drum. Wear and dust. Cables that jump the groove can chew the drum’s edge and must be replaced as a pair.
  • Drum is cracked, or the set screws have walked loose. The drum is spinning free of the shaft instead of winding the cable. This is a hardware failure, not an opener problem.
  • Grinding or popping from the header as the door travels. A worn drum and a stretched cable are fighting each other. Left longer, the shaft and bearing plates take the stress.
Before & after

See the difference

Before - Recent ProjectBeforeAfter - Recent ProjectAfter
Recent Project
Before - Full RestorationBeforeAfter - Full RestorationAfter
Full Restoration
Before - Complete UpgradeBeforeAfter - Complete UpgradeAfter
Complete Upgrade

Replacement Cost & What’s Included

For Summerlin, cable-and-drum work sits in our Cable Repair range of $130 – $250 installed for a standard residential door. What moves you within that range: number of cables replaced (one or both), whether the drums are replaced too, cable diameter and length, and whether the door needs re-leveling after the swap. If a bent track or damaged panel is also in play, that’s separate work and we’ll quote it plainly.

Here’s how the price breaks down for you:

  • Parts: cables and drums, OEM or quality aftermarket, at a price we state up front.
  • Labor: the removal, the install, and balancing both sides so the door runs true.
  • Not included: springs, opener repair, or panel work. If we find any of that while we’re in there, we tell you before touching it.

Every cable-and-drum job we do is covered by our 90-Day Done Right Promise: if it isn’t right, we come back, in writing, no arguing. The flat price is quoted and agreed before any work starts, so there are no surprises on the bill.

DIY or Call Us?

We’ll be honest about what’s safe. You can look at the cables and drums visually and describe what you see. You can check that the door runs level in the closed position, and you can take a photo of the label and the drum to send us. That helps us quote accurately.

What you should not do is try to rewind the cable onto a drum, loosen a set screw, or take tension off the torsion spring yourself. The spring holds the door’s entire weight, and the cable is what transfers that load to the drum. A cable under load can snap with enough force to do serious injury, and we’ve seen too many homeowners hurt trying to “just get the door down.” On a Genie system, the drum and the wound spring sit inches apart. If your cable has failed, call us at (855) 608-8802 and we’ll get a technician out to make it safe.

FAQs

Need Garage Door help nationwide? Licensed & insured · same-day response · free estimates
Call (855) 608-8802
Local Service Coverage

Request a Free Estimate in Summerlin

Tell us what you need - Mainspring Garage Door Co. Summerlin responds fast. No obligation.

By submitting this form you agree to our Privacy Policy and consent to be contacted by phone, email or SMS about your request, including by local professionals who may handle it.

Prefer to text? Send a Text
Call Now - 24/7 Dispatch