Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the pro arrives.
Get your free estimateGenie Torsion Spring Replacement: The Summerlin Owner’s Guide
We replace Genie-compatible torsion springs in Summerlin for $180 to $340 installed, and most of these jobs are finished the same day you call. The spring carries the full weight of the door, so when it goes, the door usually won’t lift or drops hard. Owners find out fast: a loud bang from the garage, an opener that suddenly can’t raise the door more than a foot, or a door that feels impossibly heavy when you try it by hand. If the door is stuck open, stay out from under it and call us at (855) 608-8802.
We’re Mainspring Garage Door Co., an independent service provider. We are not affiliated with Genie, and we don’t claim any connection to them. What we are is factory-familiar with the Genie line and stocked for the spring sizes your Summerlin door most likely uses, so we can match the right part and get it working in one visit.
Key Takeaways
- Genie-compatible torsion spring replacement in Summerlin runs $180 to $340 installed, parts and labor.
- Most replacement jobs are done in a single visit because we arrive with the springs on the truck.
- If a spring has snapped, the door is under load and unsafe to operate. Don’t try to lift it yourself.
- Every job is quoted upfront and backed by our 90-Day Done Right Promise, in writing.
Which Genie Models This Applies To
Torsion springs aren’t model-specific the way an opener’s logic board or a remote’s frequency is. The spring is chosen by what it has to carry: your door’s weight, its height, and whether it has one spring or two. So this applies across the Genie residential line, including the 1000, 2000, and 700-series doors and the opener-driven doors where a Genie opener (SilentMax, ChainMax, Screw Drive) is paired with a standard sectional door. If you have Genie branding on the door, the label on the inner edge of the left door panel or a sticker inside the garage usually carries the model and, on newer units, a door-weight rating.
The spring itself is identified by three things we measure on arrival: the wire gauge, the inside coil diameter (usually 1 3/4 inch or 2 inch on residential doors), and the spring length. A common compatibility gotcha is that left and right springs on a two-spring door are wound in opposite directions, one coiled one way, one the other. Installing two wound the same direction loads the shaft unevenly and shortens life. When we can’t read a label, we weigh the door and size the spring to the actual load rather than guessing from a chart.
On the OEM-versus-aftermarket question: Genie-branded springs exist, but for a torsion replacement a high-cycle aftermarket spring is often the better buy because you can specify the cycle rating. A standard spring is rated around 10,000 cycles; a high-cycle spring can run several times that, which matters on a daily-use door. We don’t stock parts on a truck as a promise, but our technicians bring the sizes they’ve learned Summerlin doors need. We also service LiftMaster and Chamberlain openers on the same calls.
Styles & brands we work with
- Raised-panel steel
- Carriage house
- Modern flush
- Full-view glass
- LiftMaster openers
- Chamberlain openers
Signs Your Genie Torsion Spring Replacement Is Failing
A torsion spring rarely gives warning until it’s near the end. When it does fail, here’s what Summerlin owners report:
- A loud bang from the garage. That’s the spring breaking, not the door. The stored force releases all at once, which is why you should stay clear of the door after you hear it.
- The door lifts only a few inches and stops. The opener is trying to raise a door the failed spring can no longer counterbalance. The opener is doing its job; the spring isn’t.
- The door feels extremely heavy by hand. If you can lift it a little and it feels like lifting a car, the spring’s tension is gone. On a working door, a person can raise it easily.
- A visible gap in the coil. A clean break shows as a space in the wound spring. On a ceiling-mounted torsion spring, look up at the coil with the door down, from a safe distance.
- The door slams down or drifts open. A failing spring can’t hold the door’s weight steady through the cycle, so the door drops hard or creeps past the closed position.
One Summerlin reality: our dry, hot summers and the temperature swing into winter work springs harder than a mild climate would. We routinely see standard-cycle springs reach the end of their life on doors that open and close several times a day. If your door was installed years ago and the spring has never been touched, the next replacement is a good time to move up to a high-cycle spring.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
Most Genie torsion spring replacements in Summerlin land between $180 and $340 installed. Here’s what drives where you fall in that range:
| Factor | Typical Installed Range |
|---|---|
| Single standard spring, one door | $180 – $250 |
| Two springs replaced together | $250 – $340 |
| High-cycle spring upgrade | At the top of the range |
| Cables or drums found worn during the job | Cable repair $130 – $250 if needed |
The price we quote is parts plus labor, stated before any work begins. You won’t see a surprise line on the bill. If we open it up and find a worn drum or frayed cable, we tell you the added cost and get your agreement before we touch it. Every replacement is covered by our 90-Day Done Right Promise: if the work isn’t right, we come back, in writing, no arguing.
We don’t promise same-day on new-door or full-replacement projects because those are measured and scheduled. But spring replacement is the kind of repair our trucks are set up for, and most are finished in one visit.
DIY or Call Us?
Here’s the honest line. You can safely check things by eye: look up at the coil for a visible gap, note whether the door is heavy to lift by hand, and read the model label. That’s where safe DIY ends.
A torsion spring is wound under hundreds of pounds of stored force. Replacing one means releasing, measuring, winding, and precisely balancing that force, and getting it wrong is how people get seriously hurt or wreck the door’s cables and drums. We’re not going to give you a step-by-step for that, because the wrong move can injure you. This is genuinely work for a trained professional. If your spring has broken, leave the door down if you can, keep the area clear, and call a technician.
Call (855) 608-8802 and a live person answers, day or night, weekends and holidays included. We’ll give you a straight price and a plan.
FAQs
A standard spring is rated around 10,000 cycles; a high-cycle spring lasts several times longer. A cycle is one open-and-close, so a door used four times a day uses up a standard spring in a handful of years, and the Summerlin heat and daily use speed that along. If you want a longer interval between replacements, ask us about a high-cycle spring.
No. A broken or fatigued torsion spring can’t be repaired; it has to be replaced, because the metal itself has failed. The good news is the swap is a real repair, not a patch, and it restores the door to full working order.
A single-spring replacement is usually finished within an hour or so, and a two-spring job runs a bit longer. Because our technicians bring the springs on the truck, most Summerlin jobs are done in one visit with no waiting on parts.
We match by door weight, wire gauge, coil diameter, and length, and we account for left- and right-wound springs on two-spring doors. We stock the common sizes our technicians see on Summerlin doors, and if a specific size is needed we tell you the timeline upfront. Call (855) 608-8802 for a free estimate.
Call Mainspring Garage Door Co. at (855) 608-8802 for a free estimate. A live person answers every call, and we’ll state the price before we start.
Written by the team at Mainspring Garage Door Co. Summerlin, serving Summerlin and nearby areas.